Error Code E97

AEG dryer

Error Code E97 Troubleshooting Guide

Error Code: E97 Appliance Type: Dryer Brands Affected: AEG, Electrolux, Quelle-Privileg

Description of Error E97

Error code E97 signifies a Configuration Error within the main electronic control system of your dryer. This typically means that the electronic board responsible for managing all dryer functions (the control board or main PCB) has detected an inconsistency or mismatch in its internal settings or calibration data. This is usually a software or communication issue rather than a mechanical failure.

If your AEG, Electrolux, or Quelle-Privileg dryer is displaying error code E97, please follow these steps in order:

  1. Attempt to Reconfigure the Control Unit:

    • Since this error points to a configuration issue, the initial step is to force the control unit to re-initialize or re-read its default settings.
    • Procedure: Completely disconnect the dryer from the main electrical power source (unplug it from the wall outlet or turn off the dedicated circuit breaker). Allow the appliance to remain disconnected for a minimum of five (5) minutes. This extended power-down period ensures that any residual charge in the electronic components drains completely, allowing for a hard reset of the control board’s temporary memory.
    • After the waiting period, firmly reconnect the power supply and attempt to start a standard drying cycle. If the configuration was temporarily corrupted, this power cycle may resolve the E97 code.

  2. If Reconfiguration Fails, Professional Diagnosis May Be Required:

    • If the error code persists immediately after the hard reset and power-up, the configuration error is likely stored permanently or relates to a fault in the non-volatile memory of the main electronic control board.
    • In such cases, further user-level repair is generally not possible, as flashing or reprogramming the control unit often requires specialized diagnostic tools available only to authorized service technicians.
    • Action: If the initial reconfiguration attempt is unsuccessful, the electronic control board itself may require replacement. Contact an authorized service provider for your AEG, Electrolux, or Quelle-Privileg appliance to schedule a technical inspection and potential module replacement.

Similar error codes for dryer from AEG