Error Code E00

Error Code E00 on your AEG, Electrolux, Quelle, or Privileg Dryer?

The error code E00 on your AEG, Electrolux, Quelle, or Privileg tumble dryer is usually not a cause for panic. This code indicates that no errors are stored in your appliance’s memory. It often appears briefly after a reset or when the dryer is in diagnostic mode.

What does error code E00 mean?

The code E00 signals that the dryer’s error memory is empty and that no fault has been detected. This can occur when the dryer has been put into diagnostic mode, or after a reset of the appliance. Normally, the display disappears automatically after a few seconds.

Possible causes of error code E00

• Diagnostic mode activated: The error code E00 often appears if the appliance has been put into diagnostic mode to read stored error codes.
• No stored error: The code indicates that there is currently no fault and that the error memory is empty.
• Display after reset: After a reset of the appliance, E00 may briefly appear on the display before disappearing.

Step-by-step solution for error code E00

1. Disconnect the dryer from the power supply: Turn off the dryer and unplug it from the wall socket to prevent electrical hazards.
2. Reconnect the dryer: Plug the dryer back into the power socket and turn it on.
3. Observe the display: If the error code E00 appears briefly and then disappears, no further action is required. Your dryer is functioning correctly.
4. Exit diagnostic mode: If you accidentally activated diagnostic mode, exit it according to the instructions in your AEG, Electrolux, Quelle, or Privileg dryer’s manual.

When should you contact a technician?

Contact AEG, Electrolux, Quelle, or Privileg customer service if:

• The error code E00 is displayed permanently.
• The dryer does not function correctly, even though no errors are reported.

A qualified technician can provide an accurate diagnosis and safely perform the necessary repairs.