Error Code E10

Washing Machine Error Code E10: No Water Supply

If you are seeing the error code E10 illuminated on the display of your Midea, LiddleSwan, or Zanussi washing machine, the appliance has failed its primary water intake check. This error specifically indicates that the pressure switch has not detected a sufficient change in the water level within the drum, or sufficient water flow, over a period of three (3) minutes since the start of the fill cycle. Essentially, the machine thinks it is not receiving any, or enough, water.

Please perform the following detailed checks, beginning with external factors:

Checking the External Water Supply and Connections

• Is the water tap fully open and functioning correctly?

  • The most common cause of the E10 error is an insufficient water flow rate. Ensure that the specific water tap (faucet) supplying the washing machine is completely turned on to its maximum setting.
  • A tap that is only partially opened may provide enough water to trickle into the machine, but not enough to meet the flow rate required by the pressure sensor within the three-minute timeout period.
  • Verification Step: Turn the tap completely off, then fully turn it back on to ensure the valve is seating and flowing correctly. If the tap controls multiple devices, verify water pressure is normal for other uses.

• Is the supply hose blocked, kinked, or damaged?

  • The hose carrying water from the wall tap to the back of the washing machine must allow unrestricted flow.
  • Check for Kinks: Ensure the hose has not been bent or crushed, particularly if the washing machine has recently been moved or pushed too close to the wall. A kink severely restricts water flow.
  • Check for Internal Blockages (Filter Screens): Inspect the small mesh filter screen located inside the connection point where the hose screws into the back of the washing machine. Over time, sediment, rust, or debris can accumulate on this screen, reducing the available water pressure and triggering the E10 fault. This filter may need to be carefully removed (using pliers, if necessary) and cleaned under running water.

Internal Component Check (Requires Technician)

• Possible faulty inlet valve:
  • If you have confirmed that the water tap is fully open and the supply hose is clear, straight, and the internal filter screen is clean, the problem likely lies within the appliance’s internal components.
  • The inlet valve is an electrically operated solenoid component that opens and closes to control the precise entry of water into the drum. If this valve fails, either mechanically (stuck closed) or electrically (not receiving power from the control board, or having a coil failure), the machine will not receive water even if the external supply is perfect.
  • Safety Notice: Diagnosis and replacement of the inlet valve require opening the appliance casing and handling electrical components. This must be performed by a qualified appliance repair technician or an authorized service representative due to the risk of electric shock and potential further damage to the machine’s complex systems.

If the simple checks (tap and hose) do not resolve the E10 error, please disconnect the appliance from the electrical supply and contact an authorized repair technician or the brand’s customer service for further assistance.